Waterproof IP67 COB LED Strip with Remote Control, AC 220V Dimmable Direct Plug, Sticker for Swimming Pool, Garden, Living Room, Patio (2700K Warm, 15M)

220-230V Waterproof COB LED Strip with Remote Control: This outdoor COB LED strip plugs directly into a 220-230V socket and requires no external power or transformer. Plug it in and play! With a high colour rendering index (CRI > 90), a power consumption of 10 W/m, a density of 288 LEDs/m and a luminous flux of 800 lm/m, COB technology offers uniform and continuous light, for realistic and brilliant illumination, ideal for indoor and outdoor use. IP67 waterproof rating and double flame retardant protection: Our COB LED strips are sealed with a silicone gasket with IP67 protection, ideal for temporary immersion or outdoor use in rain and snow. The outer layer is made of flame retardant rubber and the controller housing is made of flame retardant ABS V.0. This double protection ensures optimal safety both indoors and outdoors. Caution: Protect the controller and connector from moisture. Special RF Remote Control with Dimmer: This LED strip is supplied with an RF remote control allowing easy operation up to a distance of 10-20 m. It offers eight brightness levels, from 0% to 100%, allowing flexible control of the light intensity. Six dynamic light effects, each with its own speed, are available to create the perfect mood in any setting. Note: The remote requires two AAA batteries (not included). FLEXIBLE, CUTTABLE AND SELF-ADHESIVE - This 230V LED strip is available in lengths of 15m, 25m and 40m. Cut marks are provided every 50 cm. Please disconnect the power before cutting off. Seal the cut end with adhesive and protective cap. Unused portions cannot be reused. The tape is flexible and self-adhesive, allowing easy application to flat or slightly curved surfaces. Versatile use: This COB LED strip is suitable for many environments, whether it is living room, bedroom, patio, garden. It meets various lighting needs, both indoors and outdoors. Before installation, we recommend that you unroll the LED strip completely and test it before attaching, otherwise the heat may be too high and the adhesive layer may melt. Our customer service team is at your disposal to answer all your questions.