1/5
Perforatrice hydraulique 22-60 mm - Pour tôle - Avec cylindre - Pompe hydraulique - 10 tonnes - Pour métallurgie, essence, appareils électriques
3€Offerts
À appliquer en page paiement :
- Offre valable exclusivement aujourd’hui.
Vous achetez pour votre entreprise ?
+10% offert sur votre 1ère commande
-5% sur ce produit avec les tarifs négociés
Produit similaire livré par
'/%3E%3C/svg%3E)
Workpro – Pince emporte-pièce 6 tailles de perforation – Acier A3 – Poignée ergonomique antidérapante – Pour cuir, tissu, plastique, papier
15,99 €
67
Vendu par SanBouSi
Ces articles peuvent vous intéresser !
Comparer à des articles similaires
Souvent achetés ensemble
Informations produit
Description
Operating instructions:
1. Use a electric drill to punch a work piece to make a guide hole before using the hydraulic hole punch.
2. Whirl the pulling rod into the screw of piston cylinder, then ring the rod with a gasket and pass through the lower cutting die with the rod.
3. Put the pulling rod into the guide hole, and whirl the upper cutting die through the rod to make the upper cutting die, work piece and the lower cutting die connected tightly.
4. Shut the spill valve clockwise, and then press down the hand lever repeatedly to make the piston pump work. When the oil pressure climbing and shear force between the cutting die increasing, the die is starting to punch until it finishes. After punching, the hand lever must be stopped pressing down immediately.
5. Loose the spill valve anticlockwise to release the oil pressure.
6. After punching, the punch kit should be detached to clean thoroughly.
Package Content:
1 x Hydraulic Hole Punch
1 x Small-size Pulling Rods
1 x Big-size Pulling Rod ( for 10 Ton )
1 x Carrying Case
1 x Manual
1 x Hose
6x Cutting Dies
1. Use a electric drill to punch a work piece to make a guide hole before using the hydraulic hole punch.
2. Whirl the pulling rod into the screw of piston cylinder, then ring the rod with a gasket and pass through the lower cutting die with the rod.
3. Put the pulling rod into the guide hole, and whirl the upper cutting die through the rod to make the upper cutting die, work piece and the lower cutting die connected tightly.
4. Shut the spill valve clockwise, and then press down the hand lever repeatedly to make the piston pump work. When the oil pressure climbing and shear force between the cutting die increasing, the die is starting to punch until it finishes. After punching, the hand lever must be stopped pressing down immediately.
5. Loose the spill valve anticlockwise to release the oil pressure.
6. After punching, the punch kit should be detached to clean thoroughly.
Package Content:
1 x Hydraulic Hole Punch
1 x Small-size Pulling Rods
1 x Big-size Pulling Rod ( for 10 Ton )
1 x Carrying Case
1 x Manual
1 x Hose
6x Cutting Dies
Caractéristiques
- MarqueSANBOUSI
- Type d'emporte piècePince
- Réf. ManoManoME225939031
- MMID764213362660
- Réf. fabricant2026012594
- EAN8026542996443
'/%3E%3C/svg%3E)
Vous êtes ici :
'/%3E%3C/svg%3E){kind=small}