Foldable Silicone Sealing Strip for Shower Dam Shower Seal Shower Barrier Anti Overflow for Bathroom, Sink, Kitchen, 25 x 15 mm White

Installation Method: 1. Measurement: Measure the length and width of the countertop. In the corner, we recommend cutting it to 45 degrees, then connect two parts to ensure its firmness. 2. Remove the adhesive: during this step, avoid dust on the tape so as not to affect its adhesion. 3. USE THE GLUE: The most important and necessary step is to fill the bottom edge of the shower threshold with glue to ensure a durable and strong adhesion. NOTICE: In order to achieve a stable and effect, please pay attention to the following tip: 1. Buy a size 5-10 cm longer than the required length. 2. Clean the floor and dry it before installation. 3. This joint is suitable for flat and smooth floors, such as marble floors, coated floors and other smooth surfaces. It cannot be used for heavily sagging floors and ridges, large space floors and mosaic glass floors. 4. Do not peel off the whole sticker at once:Mark the position and measure the appropriate length before peeling off the sticker, peel off the sticker little by little on one side and press the exposed part on the surface at the same time, then peel off the sticker little by little on the other side. Do not peel off the entire sticker once and pull the water retention tape if it is not properly installed. 5. Use with glue: Fill the space between the walls with both ends of the water dam and all the way around the bottom with silicone sealant to achieve a completely airtight effect, remove excess glue to make contact smooth. After the installation is complete, it should be kept dry for 24 hours. In autumn and winter, it should be left for 1-2 days.