1/5
Electric Motor Brush Holder Cap Plastic Black Thread 17.5mm/0.3"/0.71" Outer Diameter 8mm Height Pack of 4
(30,78€/pc)
Dont éco-participation : 0,02 € TTC
Vous achetez pour votre entreprise ?
Tarifs négociés HT jusqu'à -20%
Produit similaire livré par
'/%3E%3C/svg%3E)
Cyclingcolors – Condensateur CBB60 10uF 450V – 2 fils 100mm – Accessoire moteur électrique pour démarrage compresseur et pompe à eau
15,95 €
58
Vendu par PRIMEROX S.R.L.
Ces articles peuvent vous intéresser !
Comparer à des articles similaires
Informations produit
Description
Black round cap for carbon brush holder, used as cover for installing carbon brushes in power tools, suitable for most motors. Suitable for hammer, electric saw, electric grinder, cutting machine, etc. Set of 4 carbon brush holder caps; Outer diameter: 18 mm/0.71 inches; Height: 7.5 mm/0.3 inches; Material: plastic. The cap is made of durable black plastic for the carbon brush holder. It is a good substitute for the old carbon brush cap. It has good heat and wear resistance, good corrosion resistance, good sealing performance, waterproof and dustproof, smooth surface and precise thread, which can accurately match the machine. After removing the carbon brush holder, remove the caps, replace the brush caps you received. Measure the old cap with a caliper, if the measured diameter is about 11.5mm, it is recommended to order a 12mm carbon brush cap. Tip: When installing the carbon brush and cap, make sure that the square back cap of the brush holder is pressed against the electrical contact part, and then fixed. The outer diameter of the cover should match the hole diameter of the position where the carbon brush is installed. Please pay attention to the size before ordering.
Caractéristiques
- MarqueAUTRES
- Quantité par pack4
- MatièresPlastique
- Poids10 g
- Réf. ManoManoME246150629
- MMID384516311547
- Réf. fabricantHZ3P-B0CV568M44
Vous êtes ici :
'/%3E%3C/svg%3E){kind=small}