Door Edge Protector, Decorative Rubber Protector, 1/16.4 Inch U-Shaped Edge Protector, Fit Most Cars (Clear 16.4 Feet/5m)

This door edge protector is made from rubber, waterproof and moisture-proof. It stays securely in place even in extreme weather conditions, has a longer service life, does not fade or chip, is scratch and wear resistant, has good anti-aging properties and is easy to clean. The rubber protective strip on the edge of the door is 5 m long. The material is soft, it can be easily bent along the edge of the door, it fits perfectly, it is not easy to peel off, it is as shiny as new glue after being torn, it leaves no trace when torn, it does not leave glue residue, it does not damage the paint, your door stays clean. The U-shaped door protection device is equipped with strong double-sided tape, which can be easily peeled off and installed without glue. In cold weather, use a heat gun to heat the rubber trim on the edge of the door before installation to facilitate and secure installation. Before installation, clean the edge of the door and make sure it is dry and clean. Then measure the dimensions of your door and use scissors to cut the decorative rubber trim to the required length. Finally, remove the adhesive film and install it, then gently pat it with your hand to make sure it adheres perfectly to the door. After installation, you can still open and close the door easily. Our door edge protectors fit most cars and can be installed on the edges of front doors, rear doors, tailgates and bonnets. They can also be used on the edges of hatches, storage cabinets, signs, tables, wooden boards, glass, steel plates, etc.