COB LED Strip 1M 24V Self-Adhesive COB LED Strip Warm White 2700K Flexible with Remote Control and Power Supply 320LED/M Cuttable Width 8 mm Indoor Lighting for Bedroom Kitchen Home Mirror

Bright White High Density COB LED Strip: Light up your space with our ultra bright LED strips. Enjoy uniform, dot-free lighting, ideal for direct and indirect applications. LED Ribbon Connector Easily control the brightness of this dimmable COB lamp with our smart controller, allowing smooth dimming of 10-100%. COB LED Strip: COB LED strip best solution for linear lighting, 180 degree beam angle for 50% wider illumination, multiple chips on board for uniform illumination, higher luminous efficiency, higher CRI92, lower performance. Dimmable Brightness 2700K COB LED strip is dimmable and comes with an RF remote control that allows you to adjust the brightness, so you can easily switch from 10% to 100% brightness gradually, and the warm white COB LED strip has a memory function to retain the light effect when it was last turned off. Easy to Install COB LED Strip, with power supply and RF remote control, the COB strip has a soft and high density specification level, which can also be bent at will. Strong adhesive is also used on the back, which can be easily attached to a wall or any other smooth and clean place. And you can use scissors to cut any length along the interface, or you can work as usual. Note: The adhesive film is too thin, please remove it with a sharp object. Widely Used 24V COB LED strip with a lifespan of 50,000 hours, 2700K white COB LED strip light is ideal for cabinets, mirrors, TV backlight and other dry/clean/smooth places that require DIY lighting decoration. Note: If you have purchased multiple sets of light strips and want to use them independently, or if the lights flash or turn off automatically, this indicates interference from other wireless devices. Please follow the following steps: unplug the power supply, then plug it back in. Within 5 seconds, press the SPEED- and SPEED+ buttons on the remote control simultaneously. The lights will flash once to indicate that pairing has been successful. If you have purchased multiple sets of light strips, you need to disconnect all power cables, and then plug in the power supply for each set individually.