3-Pack 433.92 MHz Gate Remote Control Compatible with GTI2/4, GT2/4, Mio TR2/4, Mio TR2N/4N, Garage Door Opener, White

This garage door remote control is more of a replacement than an original accessory. We recommend checking the compatibility list below before purchasing. Compatibility: Compatible with the following 433.92 MHz remotes: GTI2, GTI4, GT2, GT4, MIO TR2, MIO TR4, MIO TR2N, MIO TR4N, GENIE 273, GENIE 273L, GOLD 288, GOLD 289. Three code types: the red LED (standard) indicates the HCS rolling code; the green LED indicates the HT12 DIP switch; the red/green LED (alternating) indicates the DART code. Reliable performance: robust and reliable thanks to a durable ABS alloy housing. Enjoy consistent and dependable operation every time. Comfortable and user-friendly design: with a range of 50 meters and simple device setup. The compact design fits perfectly on your car key and offers you quick and convenient access at all times. Compact and portable: this handy keychain attaches easily to your car key. It fits perfectly and can be used directly as a replacement for old or damaged original parts. 4. - Battery: single battery - Compatible with GTI2 / GTI4 433.92 MHz Rolling Code: GT2 / GT4 MIO TR2 / TR4 MIO TR2N / TR4N GENIE 273 / GENIE 273L GOLD 288 / GOLD 289 Fixed code 433.92 MHz 433-1 / 433-2 / 433-4 MIO TD2 / MIO TD4 punto-2 / punto-4 GT2M / GT4M Access to the receiver required. If you are sure you can do it, you do not need to spend your money. What is the program? When a test is performed, it sends the operating signal and the LED lights up. Codes also show the HCS rolling code - red LED (Workset) DIP switch HT12 - green LED; DARTDEA Advanced Rolling Transmission - alternating red and green LED Changing the transmission code Versions T1 and T2 are no longer manufactured. When the operating LEDs light up (10 s), they stay on until the emitted code type is displayed: 1 second blink = HCS rolling code 2 seconds blink = DIP SWITCH HT12 3 seconds blink = DART Hold T1 and use T2 to change the type of blinking. Once the new code is activated, stop the T2 button while the LEDs light up (5 s). Programming with receiver (For information on the memory procedure, refer to the receiver's instruction manual.) 1. There is an LED light on the other side of the receiver board.