Mountain Forest Car Stickers Side Window Stickers for Car Hood Auto Vinyl Decal for Jeep RV Camper Van 100 x 17 cm

Specifications Material self-adhesive vinyl Dimensions 100 x 17 cm Colour black Package includes 2 x car stickers left right 1 x Scraper Installation instructions for car sticker 1 Unroll the sticker and lay it flat on a desk or floor or weigh it down with books for several hours to flatten it 2 Clean the surface of the car from dust then spray a generous amount of water on it 3 Scrape the surface of the backing paper back and forth with a squeegee several times to ensure the sticker fully adheres to the clear transfer film Place the sticker face down on a flat surface and carefully peel off the white backing paper refer to the listing photo The sticker must remain on the transfer film If the sticker adheres to the backing paper stop and reattach the backing paper slightly then press the sticker into the transfer film with your finger until it sticks Proceed slowly and patiently 4 Spray extra water on the back of the sticker to reduce its viscosity making it easier to adjust position and eliminate bubbles 5 One person holds the sticker while another aligns an edge of the sticker with the marking position and gently scrapes it with a scraper on that side Simultaneously adjust the position while removing excess water and air bubbles until the sticker fits perfectly Tip You can lift the sticker repeatedly and spray water to adjust the position or remove bubbles 6 Allow the water under the sticker to dry then carefully and slowly peel off the transfer film at 180 degrees parallel to the surface to minimize the risk of sticker detachment If part of the sticker adheres to the transfer film stop and use the scraper to press the sticker onto the surface 7 Cut off excess decal if needed 8 Perfect Enjoy and show off your decal Warm Tips 1 It is normal that the sticker transfer film is slightly wrinkled or there are bubbles due to roll packaging This will not affect the appearance of the sticker or the installation process as the transfer film will be removed once completed 2 Due to the large size of the sticker it is recommended to involve 2-3 people for optimal results during installation 3 Avoid pulling force on the sticker during application to avoid stretching or deformation 4 For persistent air bubbles pierce them with a small pin and smooth the area with light pressure 5 Do not wax the car in the week before applying the sticker as the wax may interfere with its adhesion 6 Avoid washing the car within a week or exposing it to direct sunlight within 24 hours of installation