Mini EMS facial slimming and electromagnetic microcurrent massage device, facial lifting beauty device 02276-AquaForge

EMS facial massager for a slimming and facelifting effect. Instructions: 1. Open the battery compartment, insert 2 AAA batteries, then close it. * Observe the correct battery polarity. 2. Attach the electrodes: A. Choose a suitable electrode (smaller for the eyes, larger for the chin). B. Clean and dry the area to be treated before use. C. Connect the electrode and the power cords. D. Plug the device into the power outlet. E. Remove the protective film from the electrode and apply it to the face. F. Before switching on the device, check that both electrodes are correctly positioned on the area to be treated. 3. Press the on/off switch to start the device, then press the menu button to select the operating mode. 4. After selecting the desired mode, proceed with the treatment. * The treatment cycle lasts 15 minutes. The device will automatically shut off after 15 minutes. If you wish to stop the device after 15 minutes, press the (OFF) button until the intensity/speed is at its minimum, press the (S/P) button, and then press the (OFF) button again until the intensity/speed is at its minimum. Finally, press the resume (shutdown) button twice to stop the device. 5. Selecting the intensity level: Press the (menu) button. The default intensity level is the lowest. Press (on)/(off) to increase/decrease the intensity level. 6. Selecting the speed level: Press (on)/(off) to increase/decrease the speed level. * After setting the speed, if you wish to adjust the intensity level, press the (S/P) button once. * After setting the intensity level, if you wish to adjust the speed level, press the (S/P) button once. Important note: Due to the effectiveness of the other modes (2 to 4), this mode is not suitable for eye massage. Therefore, to massage the eye contour, choose mode 1.