20 x Rigid Wire Mesh Diameter 10 mm, 2 Holes Clamp for Fixing Pipes and Cables

Size & Quantity : Package included 20 x Mounting Clamp, Thickness: 1.3mm, Width: 14mm, Mounting Hole Diameter: 10mm x 6.5mm, Suitable for mounting tube diameter: Ø 10mm.

Reinforced design: stainless steel clamp with a thickness of up to 1.3 mm; the fastening clamps are made of 304 stainless steel, resistant to high temperatures up to 800 °C and low temperatures up to -196 °C, suitable for piping systems requiring high temperature resistance and relatively large loads, can provide reliable fixing support.

Reinforced rib structure The fixing flange is designed in one piece by stamping, bending and U-cutting, which especially strengthens the rib design, thereby increasing the strength and anti-deformation performance. This design also allows for better distribution and absorption of different stresses and vibrations.

Areas of use These fixing clamps are widely applied to fix pipes to the floor, ceilings and exterior walls. They can be used for fixing heat pipes such as hot water, steam, water supply and heating pipes, as well as sprinkler systems, in high temperature piping systems.

Installation Method : Select the collar size suitable for the outer diameter of the pipe, determine the hole positions according to the hole diameters and the location of the clamp, and then tighten the screws. You can place a thin washer of soft material between the collar and hose to reduce vibration and noise.